FAA proposes to adopt a new airworthiness directive (AD) for certain The Boeing Company Model 737–8 and Model 737–9 airplanes

FAA proposes to adopt a new airworthiness directive (AD) for certain The Boeing Company Model 737–8 and Model 737–9 airplanes

Read the published document below:

ACTION:

Notice of proposed rulemaking (NPRM).

SUMMARY:

The FAA proposes to adopt a new airworthiness directive (AD) for certain The Boeing Company Model 737–8 and Model 737–9 airplanes. This proposed AD was prompted by a Boeing review of the standby power system control unit (SPCU) design where a single point of failure exists internal to the SPCU. This proposed AD would require the installation of four diodes and changing wire bundles in the P5 panel, as well as performing installation and power tests and applicable on-condition actions. The FAA is proposing this AD to address the unsafe condition on these products.

DATES:

The FAA must receive comments on this proposed AD by April 1, 2024.

ADDRESSES:

You may send comments, using the procedures found in 14 CFR 11.43 and 11.45, by any of the following methods:

• Federal eRulemaking Portal: Go to regulations.gov. Follow the instructions for submitting comments.

• Fax: 202–493–2251.

• Mail: U.S. Department of Transportation, Docket Operations, M–30, West Building Ground Floor, Room W12–140, 1200 New Jersey Avenue SE, Washington, DC 20590.

• Hand Delivery: Deliver to Mail address above between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays.

AD Docket: You may examine the AD docket at regulations.gov under Docket No. FAA–2024–0229; or in person at Docket Operations between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays. The AD docket contains this NPRM, any comments received, and other information. The street address for Docket Operations is listed above.

Material Incorporated by Reference:

• For service information identified in this NPRM, contact Boeing Commercial Airplanes, Attention: Contractual & Data Services (C&DS), 2600 Westminster Blvd., MC 110–SK57, Seal Beach, CA 90740–5600; telephone 562–797–1717; website myboeingfleet.com.

• You may view this service information at the FAA, Airworthiness Products Section, Operational Safety Branch, 2200 South 216th St., Des Moines, WA. For information on the availability of this material at the FAA, call 206–231–3195. It is also available at regulations.gov by searching for and locating Docket No. FAA–2024–0229.

FOR FURTHER INFORMATION CONTACT:

Hoang Yen Dang, Aviation Safety Engineer, FAA, 2200 South 216th St., Des Moines, WA 98198; telephone 206–231–3610; email Hoang.Yen.T.Dang@faa.gov.

SUPPLEMENTARY INFORMATION:

Comments Invited

The FAA invites you to send any written relevant data, views, or arguments about this proposal. Send your comments to an address listed under ADDRESSES . Include “Docket No. FAA–2024–0229; Project Identifier AD–2023–00485–T” at the beginning of your comments. The most helpful comments reference a specific portion of the proposal, explain the reason for any recommended change, and include supporting data. The FAA will consider all comments received by the closing date and may amend this proposal because of those comments.

Except for Confidential Business Information (CBI) as described in the following paragraph, and other information as described in 14 CFR 11.35, the FAA will post all comments received, without change, to regulations.gov, including any personal information you provide. The agency will also post a report summarizing each substantive verbal contact received about this NPRM.

Confidential Business Information

CBI is commercial or financial information that is both customarily and actually treated as private by its owner. Under the Freedom of Information Act (FOIA) (5 U.S.C. 552), CBI is exempt from public disclosure. If your comments responsive to this NPRM contain commercial or financial information that is customarily treated as private, that you actually treat as private, and that is relevant or responsive to this NPRM, it is important that you clearly designate the submitted comments as CBI. Please mark each page of your submission containing CBI as “PROPIN.” The FAA will treat such marked submissions as confidential under the FOIA, and they will not be placed in the public docket of this NPRM. Submissions containing CBI should be sent to Hoang Yen Dang, Aviation Safety Engineer, FAA, 2200 South 216th St., Des Moines, WA 98198; telephone 206–231–3610; email Hoang.Yen.T.Dang@faa.gov. Any commentary that the FAA receives that is not specifically designated as CBI will be placed in the public docket for this rulemaking.

Background

The FAA has received a report indicating that a Boeing review of the SPCU design revealed that a potential single point of failure exists internal to the SPCU. This condition, if not addressed, could result in a non-latent single point of failure, which can result in a non-latent loss of the entire battery buss and consequent un-annunciated loss of control and indication of both engine anti-ice (EAI) systems.

The unsafe condition, if not addressed, could result in loss of thrust on both engines due to damage from operation in icing conditions without EAI and can result in loss of continued safe flight and landing.

FAA’s Determination

The FAA is issuing this NPRM after determining that the unsafe condition described previously is likely to exist or develop on other products of the same type design.

Related Service Information Under 1 CFR Part 51

The FAA reviewed Boeing Alert Requirements Bulletin 737–30A1083 RB, dated November 18, 2022. This service information specifies procedures for the installation of four diodes and changing wire bundles in the P5 panel, as well as performing an anti-ice diode installation test and an engine anti-ice and wing anti-ice power test and applicable on-condition actions. On-condition actions include doing applicable corrective actions until the tests are passed.

This service information is reasonably available because the interested parties have access to it through their normal course of business or by the means identified in ADDRESSES .

Proposed AD Requirements in This NPRM

This proposed AD would require accomplishing the actions specified in the service information already described and except for any differences identified as exceptions in the regulatory text of this proposed AD. Interim Action.

Costs of Compliance

The FAA estimates that this AD, if adopted as proposed, would affect 205 airplanes of U.S. registry. The FAA estimates the following costs to comply with this proposed AD:

The FAA has received no definitive data on which to base the cost estimates for the on-condition actions specified in this proposed AD.

The FAA has included all known costs in its cost estimate. According to the manufacturer, however, some or all of the costs of this proposed AD may be covered under warranty, thereby reducing the cost impact on affected operators.

Authority for This Rulemaking

Title 49 of the United States Code specifies the FAA’s authority to issue rules on aviation safety. Subtitle I, section 106, describes the authority of the FAA Administrator. Subtitle VII: Aviation Programs, describes in more detail the scope of the Agency’s authority.

The FAA is issuing this rulemaking under the authority described in Subtitle VII, Part A, Subpart III, Section 44701: General requirements. Under that section, Congress charges the FAA with promoting safe flight of civil aircraft in air commerce by prescribing regulations for practices, methods, and procedures the Administrator finds necessary for safety in air commerce. This regulation is within the scope of that authority because it addresses an unsafe condition that is likely to exist or develop on products identified in this rulemaking action.

Regulatory Findings

The FAA determined that this proposed AD would not have federalism implications under Executive Order 13132. This proposed AD would not have a substantial direct effect on the States, on the relationship between the national Government and the States, or on the distribution of power and responsibilities among the various levels of government.

For the reasons discussed above, I certify this proposed regulation:

(1) Is not a “significant regulatory action” under Executive Order 12866,

(2) Would not affect intrastate aviation in Alaska, and

(3) Would not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act.

List of Subjects in 14 CFR Part 39

• Air transportation
• Aircraft
• Aviation safety
• Incorporation by reference
• Safety

The Proposed Amendment

Accordingly, under the authority delegated to me by the Administrator, the FAA proposes to amend 14 CFR part 39 as follows:

PART 39—AIRWORTHINESS DIRECTIVES

1. The authority citation for part 39 continues to read as follows:

Authority: 49 U.S.C. 106(g), 40113, 44701.

2. The FAA amends § 39.13 by adding the following new airworthiness directive:

The Boeing Company: Docket No. FAA–2024–0229; Project Identifier AD–2023–00485–T.

(a) Comments Due Date

The FAA must receive comments on this airworthiness directive (AD) by April 1, 2024.

(b) Affected ADs

None.

(c) Applicability

This AD applies to The Boeing Company Model 737–8 and 737–9 airplanes, certificated in any category, having a line number identified in paragraph 1.A., “Effectivity,” of Boeing Alert Requirements Bulletin 737–30A1083 RB, dated November 18, 2022.

(d) Subject

Air Transport Association (ATA) of America Code 30, Ice/Rain Protection System.

(e) Unsafe Condition

This AD was prompted by a Boeing review of the standby power system control unit (SPCU) design that determined a potential single point of failure exists in the SPCU. The FAA is issuing this AD to address a potential single point of failure in the SPCU, which can result in a non-latent loss of the entire battery buss and consequent un-annunciated loss of control and indication of both engine anti-ice (EAI) systems. The unsafe condition, if not addressed, could result in loss of thrust on both engines due to damage from operation in icing conditions without EAI and can result in loss of continued safe flight and landing.

(f) Compliance

Comply with this AD within the compliance times specified, unless already done.

(g) Required Actions

Except as specified by paragraph (h) of this AD: At the applicable times specified in the “Compliance” paragraph of Boeing Alert Requirements Bulletin 737–30A1083 RB, dated November 18, 2022, do all applicable actions identified in, and in accordance with, the Accomplishment Instructions of Boeing Alert Requirements Bulletin 737–30A1083 RB, dated November 18, 2022.

Note 1 to paragraph (g):

Guidance for accomplishing the actions required by this AD can be found in Boeing Alert Service Bulletin 737–30A1083, dated November 18, 2022, which is referred to in Boeing Alert Requirements Bulletin 737–30A1083 RB, dated November 18, 2022.

(h) Exceptions to Service Information Specifications

(1) Where the Compliance Time columns of the table in the “Compliance” paragraph of Boeing Alert Requirements Bulletin 737–30A1083 RB, dated November 18, 2022, uses the phrase “the original issue date of Requirements Bulletin 737–30A1083 RB,” this AD requires using the effective date of this AD.

(2) Where “ACTION 3” in the Action column of the table in the “Compliance” paragraph of Boeing Alert Requirements Bulletin 737–30A1083 RB, dated November 18, 2022, specifies to do applicable corrective actions and repeat the test until the test passes if any test fails, for this AD, the compliance time for those actions is before further flight after accomplishing the test.

(i) Alternative Methods of Compliance (AMOCs)

(1) The Manager, AIR–520, Continued Operational Safety Branch, FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. In accordance with 14 CFR 39.19, send your request to your principal inspector or responsible Flight Standards Office, as appropriate. If sending information directly to the manager of AIR–520, Continued Operational Safety Branch, send it to the attention of the person identified in paragraph (j)(1) of this AD. Information may be emailed to: 9-ANM-Seattle-ACO-AMOC-Requests@faa.gov.

(2) Before using any approved AMOC, notify your appropriate principal inspector, or lacking a principal inspector, the manager of the responsible Flight Standards Office.

(3) An AMOC that provides an acceptable level of safety may be used for any repair, modification, or alteration required by this AD if it is approved by The Boeing Company Organization Designation Authorization (ODA) that has been authorized by the Manager, AIR–520, Continued Operational Safety Branch, FAA, to make those findings. To be approved, the repair method, modification deviation, or alteration deviation must meet the certification basis of the airplane, and the approval must specifically refer to this AD.

(j) Related Information

(1) For more information about this AD, contact Hoang Yen Dang, Aviation Safety Engineer, FAA, 2200 South 216th St., Des Moines, WA 98198; telephone 206–231–3610; email Hoang.Yen.T.Dang@faa.gov.

(2) Service information identified in this AD that is not incorporated by reference is available at the addresses specified in paragraphs (k)(3) and (4) of this AD.

(k) Material Incorporated by Reference

(1) The Director of the Federal Register approved the incorporation by reference (IBR) of the service information listed in this paragraph under 5 U.S.C. 552(a) and 1 CFR part 51.

(2) You must use this service information as applicable to do the actions required by this AD, unless the AD specifies otherwise.

(i) Boeing Alert Requirements Bulletin 737–30A1083 RB, dated November 18, 2022.

(ii) [Reserved]

(3) For service information identified in this AD, contact Boeing Commercial Airplanes, Attention: Contractual & Data Services (C&DS), 2600 Westminster Blvd., MC 110–SK57, Seal Beach, CA 90740–5600; telephone 562–797–1717; website myboeingfleet.com.

(4) You may view this service information at the FAA, Airworthiness Products Section, Operational Safety Branch, 2200 South 216th St., Des Moines, WA. For information on the availability of this material at the FAA, call 206–231–3195.

(5) You may view this material at the National Archives and Records Administration (NARA). For information on the availability of this material at NARA, visit www.archives.gov/​federal-register/​cfr/​ibr-locations or email fr.inspection@nara.gov.